Šifra proizvoda: #22177

FAN VOLTREG 12V 2/3W

DC PWM 2/3 Wire Fan Temperature Controller with NTC 50K, 0.8A, 9-14V

Working voltage: DC12V (9-14V range)
Input reverse connection protection: Yes
No output overload protection
Power interface: XH-3P terminal block (pin spacing 2.54mm)
Fan current: 0.8A (not overloaded)
Fan interface: KF2510-3P terminal block (pin spacing 2.54mm)
Temperature probe parameters: NTC 50K B=3950 Length= 50cm
Temperature probe interface: XH-2P terminal block (pin spacing 2.54mm)
Temperature probe temperature resistance: Ring probe 110℃
PWM output range: 5%-100%
Working temperature: -20℃č60℃
Size: 43mm X 18mm X 9mm

Precautions for use:
Since most fans can run but cannot start at low output, when setting the minimum speed of the temperature control, you should first adjust to the lowest speed and stop the fan by hand, and then increase the output step by step until the fan starts normally. Don't go below this position after the actual setting, otherwise the fan may not start when the speed is low.